Napoleon Fireplaces Tureen™ - GD82T-TE - Manuel (Page 46)

46
W415-0769 / A / 12.10.10
A. Place the door frame face down careful not to scratch the
paint.
B. Center the gasketed glass inside the door frame with the thick
side of the gasket facing up.
C. Bend the glass retainers located along the edge of the door
frame over the gasket holding the glass in place. Careful not
to break the glass.
GLASS
GASKET
DOOR
FRAME
GLASS
RETAINER
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
56.1
Your comes equipped with our “Night Light™”.
The light has been pre-wired and is controlled from the remote
control.
If in the event the lamp or lens needs to be replaced, follow the
instructions below.
Unplug the wire harness / transformer from the FCM (Fan Control
Module) inside the appliance.
Remove the four screws that secure the lens frame.
This frame retains the glass lens. The lamp can now be accessed.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect with a clean
dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as
lamp and lens are special “high temperature” products. When re-installing, ensure
integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens.
“Light Leakage” from the upper area may be observed. The holes in the lamp housing are necessary
for ventilation and must not be covered.
SCREWS
LENSE
FRAME
FIREBOX TOP
GASKET
LENSE
FRAME
COLOURED SIDE UP
11.5 NIGHT LIGHT™ REPLACEMENT
11.6 GLASS / DOOR REPLACEMENT