GE JV936DSS - Manuel (Page 10)

REMOVE THE PACKAGING
• Remove the small box housing the motor.
• Lift the hood out of the box.
• Remove shipping screws holding the wood mounting
piece to the back side of the hood. Set aside wood
mounting piece and screws for later installation. Do
not discard.
• Remove the “V” shaped carton insert.
• Remove parts package from the “V” shaped
cardboard insert.
• Remove junction box cover and knockout.
• Install strain relief onto back or top of hood.
• Remove all tape and packing material from the hood,
duct transition and motor.
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pliers
Wire Cutter/
Stripper
Tin Snips
Allen Wrench
Spirit level
Duct tape
Safety glasses
Ladder
Saber saw or Key Hole Saw
Phillips and
Flat blade
screwdirvers
Additional Materials:
• 120V 60Hz, 15 or 20 Amp, 2 wire with ground.
Properly grounded branch circuit.
• Strain relief for junction box.
•
7” round metal duct, 3-1/4” x 10” rectangular duct
or 3-1/4” x 12” rectangular duct length to suit
installatoin.
1/4” pivoting hex
socket
Hammer
Electric drill with 1/8” and
3/8” bits
Flashlight
UL Listed Wire nuts
Pencil and tape
measure
10
Wood
Mounting
Support
Hood
Parts
Package
Shipping Carton
Motor
Installation Instructions