Brother DZ1500F - Manuel (Page 9)

7
Before You Begin (1)
Power Cord
Foot Controller
Power Switch
I
O
Hand Wheel
1
2
3
4 5
6
7
Stitch Length Regulator
Reference Mark
Lower number
= shorter stitches
Higher number
= longer stitches
Stitch Length
Reverse Stitch
Lever
Upper Thread Tension
Loosen Tighten
Tension Block
Thread Tension Dial
When tighter thread tension is ●
desired, turn the tension dial
to the right. Upper and bobbin
threads will meet on right side of
the fabric.
When looser thread tension is
●
desired, turn tension dial to the
left. Upper and lower threads
will then meet on wrong side of
fabric.
Power Switch
Flip power switch to “I” position ●
to turn on.
To switch power off, flip switch to
●
“O” position.
Hand Wheel
Position needle using hand ●
wheel.
Always turn hand wheel towards ✽
you.
CAUTION
Be sure to keep the area under
and around the needle clear.
Stitch Length Regulator
Adjust desired stitch length ●
using stitch regulator dial.
Reverse Stitch Lever
Sewing in reverse is possible ●
when the reverse stitch lever is
in the lowered position.
Make sure to continuously press ✽
the lever to its lowest position
when reverse sewing is desired.
When the feed adjustment dial is
✽
set between 5-7 mm, the reverse
stitch length is always 5 mm.
Power Cord and Foot Controller
WARNING
Please use common household
current.
Plug in cord. ●
Plug foot controller into machine. ●
When you press the foot controller ●
down lightly, the machine will run
at a low speed. When you press
harder, the machine’s speed will
increase. When you take your foot
off the foot controller, the machine
will stop.
Slower
Faster