Thermolec Thermo-Air - Manuel (Page 4)

THERMO-ZONE (ZON models in Fig. 1)
When the unit is installed and connected, set the potentiometer on the controller to “R” (remote).
Install the thermostat far from a heat source, on a wall where there is no air draft. Connect the
thermostat wires to the terminals marked “ S S ” on the controller.
If you don’t fi nd the exact model you need in the table, please order a standard Thermolec heater
equipped with SCR control.
Remember : In case of trouble or for technical assistance, please use our free Help Line:
1-800-336-9130
6
18
22
28 34
0
42
R
R
24VAC
A A S S
LOAD 1 LINE LOAD 2 LINE
With remote
thermostat, adjust
Avec thermostat
à distance, ajuster
C 0 6 12 18 22 28 34 42
F 32 43 54 64 72 82 93 108 o
o
SECOND OUTPUT ON D22 ONLY
THERMOSTAT
AIRFLOW SENSOR
LOCATED AT THE
TOP OF UNIT