Gotham ICO-CYL Cylinder Rev. D - Manuel (Page 3)

CJ5200060 Rev. D
11/2013 3 of 6
©2010, 2012 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
PENDANT MOUNTED CYLINDER:
Before getting started: Not recommended for outdoor use or where cylinder will be subjected to adverse
environmental conditions unless pendant is rigidly mounted.
• Feed cylinder housing lead wire through 3/8” pendant stem as shown in Figure 1a.
• Attach stem to fitting mounted on top of cylinder housing being careful to align threads correctly.
• Make supply connections. Supply wire must meet local or national codes and be rated for a minimum of 75
0 C.
• Mount 3/8” pendant stem (may be supplied as separate catalog item) and cylinder housing to junction box.
• If necessary, clean reflector with a non-abrasive cleaner to remove dirt, fingerprints, etc. It is recommended
that reflector be cleaned periodically to retain optimum photometric performance.
WALL MOUNTED CYLINDER:
Before getting started: Housing is equipped to be mounted directly to a 4” square or 4” octagonal junction
box which must be installed with respect to the floor line.
Tool requirement: 5/64” Allen wrench.
• Loosen set screw in bottom of wall cover plate and remove mounting plate.
• Place branch circuit leads through hole in mounting plate, aligning correct hole patterns between mounting plate
and junction box and use screws supplied with junction box to securely attach mounting plate as shown in
Figure 2b.
• Attach cylinder housing by hooking wall cover plate over top section of mounting plate as shown in Figure 3b.
• Make supply connections. Supply wire must meet local or national codes and be rated for a minimum of 75
0 C.
Push completed supply connections through hole in mounting plate and into junction box.
• Secure cylinder housing to mounting plate by tightening set screw in bottom of wall cover plate.
• If necessary, clean reflector with a non-abrasive cleaner to remove dirt, fingerprints, etc. It is recommended
that reflector be cleaned periodically to retain optimum photometric performance.
• After mounting fixture to wall, place a bead of silicone-based caulking compound along where the mounting
bracket meets the wall on the top and on each side. Do NOT caulk along the bottom.
Mounting
plate
Junction
box
Figure 2b
Set screw
Junction
box
Wall cover plate
Mounting plate
Figure 3b
Stem
Pendant
fitting
Lead
wire
Figure 1a
AIRCRAFT CABLE AND CORD MOUNT CYLINDER
Before getting started: Canopy is equipped to be mounted directly to a rigidly mounted 4” junction box.
• Fasten canopy mounting pan to 4” junction box.
• On the ground, determine required length of cord and cable and make necessary cuts. (10 FEET OF
CORD AND CABLE PROVIDED). It is recommended that the cut end of cable be soldered or glued to
prevent it from fraying.
• Attach strain relief bushing to cord and install in canopy, making sure widest flat surface of the bushing will
face floor.
• Insert cable into end of cable glider, making sure the end of cable protrudes at least 1” from the cable exit
on side of glider. WARNING: CABLE SUPPORTS WEIGHT OF FIXTURE. CORD CANNOT BE USED TO
SUPPORT WEIGHT.
• Hang fixture assembly from “S” hook safety chain attached to canopy mounting pan.
• Make wire connections.
• Secure fixture canopy to canopy mounting pan making sure all screws are tightly secured.
• Fasten aircraft cable and cord together with cable stays.