Gotham ICO-CYL Cylinder Rev. D - Manuel (Page 2)

CJ5200060 Rev. D
11/2013 2 of 6
©2010, 2012 Acuity Brands Lighting, Inc.
All Rights Reserved .
SAVE THESE INSTRUCTIONS
Upon receipt, thoroughly inspect for any
freight damage which should be brought
to the attention of the delivery carrier.
Compare the catalog description listed on
the packing slip with the label on the
carton to ensure you have received the
correct merchandise.
INSTALLATION INSTRUCTIONS
ICO-CYL Cylinder
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
Warning: Risk of fire. Do not install
insulation within 3 inches of fixture
sides or wiring compartment, nor above
fixture in such a manner as to entrap
heat.
Electric current can cause painful
shock or serious injury unless handled
properly. For your safety, always
remember the following:
• Turn off the supply power.
• Ground the fixture to avoid potential
electrical shocks.
• Do not handle an energized fixture or
energize any fixture with wet hands,
when standing on a wet or damp surface,
or in water
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference,
and (2) this device must accept any
interference
received, including
interference that may cause undesired
operation.
SURFACE MOUNTED CYLINDER:
1. Remove trim assembly by pulling down on reflector and loosen the screws holding the cylinder body shown in
Figure 1. Slide the cylinder body off of the frame.
2. Remove twist-lock hinge cover plate from top of cylinder housing by releasing the twist-lock lever inside the
cylinder as shown in Figure 2.
3. Attach the twist-lock hinge cover plate directly to 4” square or octagonal junction box as shown in Figure 3
using (2) Phillips head screws provided.
4. Install the cylinder housing onto the twist-lock hinge cover plate by guiding the “T” through the hole in the top
of the cylinder as shown in Figure 4.
5. Align “T” perpendicular to hole and engage into the two small slots. Allow cylinder housing to hang from twist-
lock hinge cover plate.
6. Make supply connections. Supply wire must meet local or national codes and be rated for a minimum of
75 0 C. Push completed supply connections through hole in twist-lock hinge cover plate and into junction box..
7. Swing cylinder housing flush to the ceiling against the twist-lock hinge cover plate. Grasp the cylinder frame
with both hands and rotate the entire housing clockwise until the internal locking mechanism snaps into place
as shown in. There will be an audible “click” when the locking mechanism is fully engaged.
8. Slide the cylinder body over the frame and align the housing screws with the slots in the aperture. Tighten the
screws to secure the housing. Reinstall the reflector as shown in Figure 6.
9. If necessary, clean reflector with a non-abrasive cleaner to remove dirt, fingerprints, etc. It is recommended
that reflector be cleaned periodically to retain optimum photometric performance.
Figure 4 Figure 3
Figure 2 Figure 1
Figure 6 Figure 5
Twist-lock
lever
Housing screws