Factory Direct Hardware Hansgrohe 04169 - Manuel (Page 3)


Installation Considerations
For best results, Hansgrohe recommends that this unit be installed by a licensed, profes-
sional plumber.
Please read over these instructions thoroughly before beginning installation. Make sure
that you have all tools and supplies needed to complete the installation.
This faucet may be used with a continuous flow water heater if the flow pressure is at
least 20 PSI.
•
•
•
Solaris 2 Widespread Lavatory Faucet 04169XX0
Allegro² Widespread Lavatory Faucet 04182XX0
Metro 2 Widespread Lavatory Faucet 04195XX0
Product Specification
Requires ½" supply lines (not included)
Max. mounting surface thickness
1 1/8"
Hole sizes in mounting surface:
spout
1 /8"
valves 1 1/4"
Max. incoming water pressure 145 PSI
Recommended incoming water pressure 22 - 72 PSI
Max. incoming hot water temp. 176F*
Recommended incoming hot water temp. 120º - 140ºF*
Max. flow rate 2.2 gpm
*Please know and follow all applicable local codes when setting the temperature on the water heater.
English