S t e p4 set telephone/amplifier, S t e p5 connect to, I n s t a l l a t i o n s t e p s – Plantronics MX10 Manuel d'utilisation
Page 6: Unplug your telephone’s handset cord from the, Telephone base, Plug your telephone’s handset cord into the, Switcher amplifier handset jack ( ), Connect your telephone base to the switcher, Plug the headset cord into the quick disconnect, These are the default settings for headset use
I N S T A L L A T I O N S T E P S
2. Lift the phone’s handset off the cradle and place
3. If you don’t hear a dial tone, adjust the
Telephone/Amplifier Compatibility Switch as
indicated below:
1. Remove the Telephone Compatibility Switch Access
Door by placing two fingers or thumbs on the
raised bumps and pushing down.
2. Remove the flat, plastic screwdriver from the
bottom of the amplifier by sliding it through the
braces holding it in place.
3. Make sure the amplifier is in the default settings,
and your telephone handset is off of its cradle.
4. Using the screwdriver, slide the Compatibility
I N S T A L L A T I O N S T E P S
1. Plug the single-jack end of the
Audio Device Cable (mini-DIN) into the
external audio device jack on the rear
panel of the amplifier.
2. Plug the twin jack end of the Audio
Device Cable into the audio device,
matching the icons.
C o m p a t i b i l i t y S w i t c h
Switcher.biling.ii-25 11/4/98 7:58 PM Page 4