U s e a d v a n c e d f e a t u r e s, Recording and playing outgoing messages and music, Switch the headset/handset selector to headset – Plantronics MX10 Manuel d'utilisation

Page 13: 2 use your audio device to control recording, play, Back and volume, 3 to interrupt or take over the phone call, simply, Recording a call, Depress the telephone/computer audio switch, Record using your external audio device. your, E n g l i s h

Advertising
background image

M A I N T E N A N C E A N D
T R O U B L E S H O O T I N G

e n g l i s h

18

19

M A I N T E N A N C E A N D
T R O U B L E S H O O T I N G

e n g l i s h

P R O B L E M

I T E M S T O C H E C K

MY CALLERS SAY
THAT THEY CAN’T
HEAR ME AT ALL
OR THEY CAN’T
HEAR ME VERY
WELL.

Make sure the microphone of your headset is
positioned in front or near your mouth. If you
are using a “noise-cancelling” headset, the
position of the microphone is very important.
You may need to adjust the “Outgoing
Volume”. See “Adjusting Outgoing Volume” on
page 11.
Confirm that the Telephone/Amplifier
Compatibility Switch is in the correct setting for
your phone (see "Set the Telephone/Amplifier
Compatibility Switch” on page 4). You may
want to try moving the switch through all of the
positions until your caller hears you clearly.
Experimenting with various switch settings will
not harm the amplifier or your telephone.

Change the Telephone/Amplifier Compatibility
Switch between position 5 and 6 to see if the
hum goes away in either position. Use the posi-
tion with no hum.
Ensure the Audio Device Cable is routed away
from your monitor or other electrical device.

I GET A LOW PITCH
HUM IN MY HEADSET
SPEAKER AND/OR MY
CALLERS COMPLAIN
THEY CAN HEAR HUM.

Maintenance Hints

Trouble Shooting Guide

P R O B L E M

I T E M S T O C H E C K

I DO NOT HEAR A
DIAL TONE WHEN I
TRY TO MAKE OR
RECEIVE A PHONE
CALL.

If you are using an AC Power Supply, confirm that it
is plugged in and the power outlet is turned on.
If you are using batteries, confirm that they are
good and placed in the battery compartment cor-
rectly.
Confirm that the Headset/Handset Selector Switch is
switched to Headset ( ).
Confirm that you have lifted the telephone handset
out of the cradle.
Confirm that the telephone handset cable and the
short curly cord to the telephone are connected in
the correct jacks (see Part 1 of this guide).
Confirm that the Telephone/Amplifier Compatibility
Switch is in the correct setting for your phone (see
"Set the Telephone/Amplifier Compatibility Switch”
on page 4). You may want to try moving the switch
through all of the positions until you hear a clear
dial tone. Experimenting with various switch
settings will not harm the amplifier or your phone.

Trouble Shooting Guide

Maintenance Hints

Switcher.biling.ii-25 11/4/98 7:58 PM Page 18

Advertising