Onkyo HT-r591 - Manuel (Page 35)

Turning On & Basic Operations
En-35
The Home menu provides quick access to frequently used
settings. You can change settings and view the current
information.
Note
• The on-screen menus are displayed when:
– There is no video input, or
– The video input is 480p, 576p, 720p, 1080i, or 1080p.
Note
*1 Depending on the input source and listening mode, not all
channels shown here output the sound.
*2 • This setting is not available in either of the following cases:
–The “Audio TV Out” setting is set to “On” ( ➔ page 50 ).
–“HDMI Ctrl (RIHD)” is set to “On” ( ➔ page 49 ) and
you’re listening through your TV speakers.
With the sleep timer, you can set the AV receiver to turn
off automatically after a specified period.
Using the Home Menu
The on-screen menus appear only on a TV that is
connected to the
HDMI OUT. If your TV is connected
to other video outputs, use the AV receiver’s display
when changing settings.
1 Press RECEIVER followed by HOME.
The Home menu will be superimposed on the TV
screen.
2 Use / and ENTER to make the desired selection.
■ Input
` You can select the input source.
Use / to select the desired input source.
Pressing ENTER switches to the selected input
source.
■ Audio
` You can change the following settings: “Bass”,
“Treble”, “Subwoofer Level”, “Center Level”,
“Audyssey”, “Dynamic EQ”,
“Dynamic Volume”, “Late Night”, “Music
Optimizer”, and “Cinema Filter”.
See also:
• “Audyssey” ( ➔ page 46 )
• “Using the Audio Settings” ( ➔ page 50 )
■ Info *1
` You can view the information of the following
items: “Input” and “Output”.
■ Listening Mode *2
` You can select the listening modes that are
grouped in the following categories:
“MOVIE/TV”, “MUSIC” and “GAME”.
Use / to select the category and / to
select the listening mode. Press ENTER to
switch to the selected listening mode.
Using the Sleep Timer
1 Press RECEIVER once followed by SLEEP
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in 10
minute steps.
The SLEEP indicator lights on the AV receiver’s
display when the sleep timer has been set. The
specified sleep time appears for about 5 seconds, then
the previous display reappears.
Tip
• If you need to cancel the sleep timer, press SLEEP
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver sleeps,
press SLEEP. Note that if you press again on SLEEP as
the time being displayed is equal to 10 minutes or less, the
sleep timer will go off.