Onkyo HT-R758 - Manuel (Page 19)

En-19
Turning On & Basic Operations
Turning On/Off the AV
Receiver
Tip
• The HYBRID STANDBY indicator may light depending on the
status of settings ( ➔ page 44 ).
• For details on power management settings, see “Auto Standby”
( ➔ page 51 ).
RECEIVER
RECEIVER
ON/STANDBY
Turning On
1 Press ON/STANDBY on the front panel.
or
Press RECEIVER followed by RECEIVER on the
remote controller.
The AV receiver comes on and its display lights.
Turning Off
1 Press ON/STANDBY on the front panel.
or
Press RECEIVER followed by RECEIVER on the
remote controller.
The AV receiver will enter standby mode. To prevent
any loud surprises when you turn on the AV receiver,
always turn down the volume before you turn it off.
■ If the “Update New F/W” window appears.
When a new version of the firmware is available, the
notification window “Update New F/W” pops up. This
notification only appears when the AV receiver is
connected to your home network (
➔ page 75 ). To
perform the firmware update, follow the instructions on
screen.
Use the / and ENTER buttons on the AV receiver or
remote controller to select one of the options.
` Update Now:
Starts the firmware update.
Refer to “Firmware Update” (
➔ page 67 ).
` Remind me Later:
The update notification will pop up again the next
time you turn the AV receiver on.
` Never Remind me:
Disables the automatic update notification.
Tip
• The update notification window can be enabled or disabled in
“Update Notice” ( ➔ page 54 ).