Sanyo PLC-XE50 - Manuel (Page 49)

Setting
Power management
Time left before Lamp is off.
Press the SELECT button
at Power management and
this box appears. Select
one of three settings with
the Point
7 8 buttons, and
go to the timer with the
Point
ed buttons and set
time with the Point 7 8
buttons.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the input signal is interrupted and no
button is pressed for a certain period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display with
“No signal” appears. The countdown starts to turn off the
lamp.
Select one of the operations.
Ready……… When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp is turned on if the input
signal is reconnected or any button on the
remote control is pressed.
Shut down… When the lamp has been fully cooled
down, the power is turned off.
Off………… Power management function is off.
Then set the countdown timer with the Point 7 8 buttons.

✔ Note:
• Factory default is “Ready: 5 min.”
On start
When this function is set to “On,” the projector is
automatically turned on just by connecting the AC power
cord to an outlet.
✔ Note:
• Be sure to turn the projector off properly (see “Turning Off
the Projector” on page 20). If the projector is turned off
in the incorrect sequence, the On start function does not
operate properly.
Lamp control
You can change the brightness of the screen.
High ........... Brighter than the Normal mode.
Normal ....... Normal brightness
Auto ........... The brightness according to the input
signal.
On start