Sanyo PLC-XE50 - Manuel (Page 37)

Video Input
Press the COMPUTER button on the remote control to
select Computer 1.
Before using the COMPUTER button, select the correct
input source through Menu operation as described below.
Use the MENU button to display the On-Screen Menu.
Press the Point 7 8 buttons to move the red frame
pointer to the Input Menu icon.
1
Computer
1
Input Menu
Use the Point ed buttons to move the red arrow
pointer to Computer 1 and then press the SELECT
button.
2
After the Source Select Menu appeared for Computer
1, move the pointer to RGB (Scart) and then press the
SELECT button.
3
COMPUTER button
Computer 1
Computer *
Input Source Selection (RGB Scart 21-pin)
Direct Operation
Menu Operation
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Input Menu icon
Move the pointer to RGB (Scart)
and press the SELECT button.
Source Select Menu
Remote Control
/
COMPUTER button
When the input source is coming from
video equipment connected to the
COMPUTER IN 1 terminal with a Scart-VGA
Cable (not supplied), select RGB (Scart).
RGB (Scart)
✔ Note:
• Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is set as Monitor out (p.48).
• Computer 2 (COMPUTER IN 2/MONITOR OUT) can
accept only RGB signal.
• When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.48)
*See Note at the bottom of this page.