Hook-up guide, Remote “dc in” control hook-up, Remote “ac in” control hook-up – Monster Power HTFS500 POWERCENTER Manuel d'utilisation

Page 25

Advertising

HOOK-UP GUIDE

Remote “DC In” Control Hook-Up

This feature connects your PowerSource to an automated Home Theater control system
or allows another component with a Remote “DC Out” connection to automatically
turn on and off your PowerSource.

A) Plug the AC power cable of the component you are using to control the PowerSource

into an unswitched outlet on the PowerSource. Note: This component must deliver
a control voltage between 3-30 volts DC.

B) Plug one end of the 1/8" mini-plug (supplied) into the corresponding Remote “DC In”

connection on the PowerSource.

C) Plug the other end of the 1/8" mini-plug into the Remote “DC Out” connection on the component

that you want to turn on and off the PowerSource’s Switched Outlets when it is turned on.

Remote “AC In” Control Hook-Up

This feature connects your PowerSource to an automated Home Theater control system or allows
another component with an AC outlet connection (for example, an AV receiver or preamplifier
for example) to automatically turn on and off your PowerSource.

A) Insert the Remote “AC IN” Control cord’s female plug into the “AC IN” 120V connection.

B) Insert the Remote “AC IN” Control cord’s 2-prong male plug into a switched AC power

outlet on the component (AV receiver or preamplifier). When this device is turned on,
the outlets programmed as “Switched On” on the PowerSource will turn on immediately.
The outlets programmed as “Switched On After Delay” will turn on after the set time delay.

��

��

��

��

��

�

��

�

��

�

��

�

��

�
�

Advertising