Faber Magnum Manuel d'utilisation

Page 6

Advertising
background image

Version 08/06 - Page 6

PREPARE THE CABINET

1. Disconnect and move freestanding range from cabinet

opening to provide easier access to upper cabinet and rear

wall. Put a thick, protective covering over cooktops, set-in

ranges or countertops to protect from damage or dirt.

2. Determine and clearly mark with a pencil the center

line of the cabinet on the wall and on the underside of the

cabinet where the rangehood will be installed.

3. Determine the proper cutouts for the ductwork. Make

all necessary cuts in the walls or cabinets for the ductwork.

Install the ductwork before mounting the rangehood.

4. If the cabinet bottom is recessed, wood filler strips need

to be installed.

5. Drill four 3/16" clearance holes for hood mounting

screws.

FIGURE 4

6. Cut a 6 1/2" diameter hole in cabinet bottom as

shown.

7. Determine and make the proper cutout for the Power

Supply Cable. Use a 1 1/4" Drill Bit to make this hole. Run

the Power Supply Cable through the wall or cabinet. DO NOT

turn on the power until installation is complete. Use caulking

to seal around the wire opening.

FIGURE 5

FIGURE 6

8. Remove the grease filters USING TWO HANDS by

pulling the knob out and turning to the left.

9. Remove the terminal box cover (located on the back

wall of the hood. Remove the power supply cable knockout

using a flat-blade screwdriver. Attach strain relief in power

supply cable opening so that clamping screws are inside of

rangehood.

10. Attach damper to exhaust opening on top of the range-

hood using the two small screws from the hardware pack-

age.

INSTALL THE RANGEHOOD

1. Place the rangehood mounting screws close to the

holes in the cabinet bottom.

2. Lift rangehood into place while feeding wiring through

strain relief.

3. Insert the screws through the clearance holes and start

them into the rangehood.

4. Connect the vent system to the rangehood and seal all

joints with duct tape.

5. Connect the Power Supply Cable to the rangehood.

Attach the White lead of the power supply to the White lead

of the rangehood with a twist-on type wire connector. Attach

the Black lead of the power supply to the Black lead of the

rangehood with a twist-on type wire connector. Connect

the Green ( Green and Yellow ) ground wire under the Green

grounding screw.

6. Install the grease filters using two hands by first pulling

and turning the knob to the left so that the locking lever does

not protrude from the filter

(as in FIGURE 7). Insert the op-

posite end of the filter into the retaining channel. Insert the

knob end next, then turn knob to the right to lock the filter

into place.

FIGURE 7

7. Turn the power supply on. Turn on blower and lights.

If the rangehood does not operate, check that the circuit

breaker is not tripped or the house fuse blown. If the unit still

does not operate, disconnect the power supply and check

that the wiring connections have been made properly.

Advertising