Warning – Faber Magnum Manuel d'utilisation

Page 5

Advertising
background image

Version 08/06 - Page 5

For best results, use no more than three 90°

elbows. Make sure that there is a minimum

of 24" of straight duct between elbows if more

than one is used. Do not install two elbows

together. If you must elbow right away, do it

as far away from the hood's exhaust opening

as possible.

9 Feet Straight Duct
2 - 90˚ Elbows
Wall Cap
Total System

9.0 feet

10.0 feet

0.0 feet

19.0 feet

FIGURE 5

3.0 feet
5.0 feet

12.0 feet

0.0 feet

45˚ Elbow
90˚ Elbow
90˚ Flat Elbow
Wall Cap

FIGURE 4

CALCULATE THE DUCTRUN LENGTH

The ductrun should not exceed 35 equivalent feet

if ducted with the required minimum of 6" round

duct. Calculate the length of the ductwork by

adding the equivalent feet in

FIGURE 4 for each

piece of duct in the system. An example is given

PLAN THE DUCTWORK

The Magnum rangehood is designed to offer wide

flexibility of installations. The rangehood can be

ducted vertically or horizontally through a 6" round

vent. The unit can also be installed in a recirculating

configuration.

FIGURES 1 and 2 show vertical

and horizontal installations for this unit.

FIGURE

3 shows recirculating installation.

The Magnum requires 6" round ductwork. To

ensure that the blower performs to its highest

possible capacity, ductwork should be as short

and straight as possilbe.

WARNING! BEFORE MAKING ANY CUTS OR

HOLES FOR INSTALLATION, DETERMINE WHICH

VENTING METHOD WILL BE USED AND CAREFULLY

CALCULATE ALL MEASUREMENTS.

FIGURE 1

FIGURE 2

ceiling

enclosed soffit

side view

rangehood

cooking surface

upper

cabinet

RECIRCULATING INSTALLATIONS

For recirculating installations,

Charcoal Filters are necessary. Remove all

grease filters and set aside. Attach one charcoal filter to each end of the

blower. Each charcoal filter attaches to the black grid on the side of the

blower. Rotate the filter clockwise to install and counterclockwise to remove

(FIGURE 3C). Replace all grease filters. Some ductwork must be installed to

exhaust the rangehood back into the kitchen, either at the top of the cabinet

(FIGURE 3A) or at the face or side of the soffit (FIGURE 3B). This duct

work must not terminate into a dead air space.

ceiling

open space

side view

rangehood

cooking surface

upper

cabinet

FIGURE 3A

FIGURE 3B

FIGURE 3C

WARNING

Because of the weight and size of the

rangehood canopy, two or more people

are needed to move and safely install the

rangehood canopy.

Failure to properly lift rangehood could result

in damage to the product or personal injury.

PERSONAL INJURY HAZARD

!

Advertising