HTC PM-128 - Manuel (Page 3)

4. Thread the (5) Lock Knobs
ẩ into their respective threaded holes.
5. Slip the Central Support/Drill Tray Assembly
Ả into the adapter tube
of the Column Clamp
ạ and tighten the Locking Knob.
6. Slip the Extensions into the Central Support Assembly and tighten
with Lock Knobs.
7. Slide the Roller Support Brackets into the vertical sockets of the
Extensions and tighten with Lock Knobs.
8. Install Rollers into the Roller Support Brackets by inserting the fixed
end of the roller axle into the roller axle hole and then depress (with
a screwdriver or putty knife) the other end of the axle and slip it into
place until the end of the axle pops into the hole.
9. Adjust the height of the Roller Bracket so the top of the rollers are
even with the drill press table. Move extensions in and out as desired
to support your workpiece. To save space and reduce obstructions in
your shop, keep supports pushed in as far as possible when not in use.
Parts List
Qty Description Part No.
Ạ 1
Column Clamp Strap 2616
ạ 1 Column
Clamp/Adapter 2617
Ả 1
Central Support/Drill Tray 2618
ả 2 Extension
2792
Ấ 2
Roller Support Bracket - T 2621
ấ 2 10"
Roller 2031
Ầ 1
Column Anchor Bolts 5/16"-18x4" C307
ầ 1
Locking Nut 5/16"-18 ESNA C201
Ẩ 1 Threaded
Knob 2622
ẩ 5 Lock
Knob G101
CAUTION: Observe all safety instructions and warnings regarding
the safe use of this accessory support and your drill press.