Elmo TT-02S Manuel d'utilisation
Page 21
21
English
SETTING
UP
Specifications of the analog RGB input terminal of this product
Signal allocation
10
9 8 7 6
5 4 3
2
1
15 14 13
DSUB 15P shrink terminal (Female)
12 11
Video signal :
Horizontal synchronized signal :
Vertical synchronized signal :
Analog 0.7V(p-p) with 75
Ω terminated
TTL level (Positive/negative polarity)
TTL level (Positive/negative polarity)
Pin assignment
Pin No.
Name
Pin No.
Name
Pin No.
Name
1
Video signal (Red)
6
GND (Red)
11
GND
2
Video signal (Green)
7
GND (Green)
12
N.C
3
Video signal (Blue)
8
GND (Blue)
13
Horizontal
sync. signal
4
N.C
9
N.C
14
Vertical
sync. signal
5
GND
10
GND
15
N.C
(3) Connecting to the unit with composite video input terminal equipped
Connect the video cable with RCA pin plug to the [VIDEO OUT] terminal on the rear panel.
(4) Connecting to the PC with a USB cable
Connect a USB cable to the [USB] terminal on the rear panel.
(5) Connecting the AC adapter
Connect the DC plug of the supplied AC adapter to the [DC IN 12V] terminal on the rear
panel before inserting the AC adapter in an outlet.
Note
• As for switching-over of the image output, refer to “OUTPUT (DIP switch)” on page 12.
• To protect the unit and peripheral devices, unplug the power plug and the AC adapter,
turn OFF power switches of all other devices before connecting video cable.
• Hold the plug of cable to plug/unplug the power plug/the AC adapter or video cable.
Note
• The USB cable compliant with USB2.0 is recommended.
• If you plug into a USB connector with power on, PC may not recognize this product.
• Depending on the USB environment of PC or the USB2.0 compliant cable is
recommended. Peripheral units, the image transfer may be disturbed.
• This does not guarantee operations in any environment.