Pit Boss 28 Inch Portable Table Top Gas Griddle Assembly Guide - Manuel (Page 3)

ENGLISH
3
ASSEMBLY INSTRUCTIONS
1. INSTALLING THE FIRE BOX FEET
Parts Required:
1 x Hot Plate (#1)
1 x Fire Box (#2)
4 x Fire Box Feet (#6)
Installation:
• Carefully, lift and remove the Hot
Plate from the Fire Box.
• Next, tip the Fire Box onto its side,
exposing the bottom of the unit.
Install the Fire Box Feet by rotating
into the hole at each of the four
corners.
• Once all four Fire Box Feet are
installed, turn the unit upright and
replace the Hot Plate into position
on top of the Fire Box.
ASSEMBLY PREPARATION
Parts are located throughout the shipping carton, including underneath the griddle.
Inspect the unit and parts after removing from the protective shipping carton. Discard
all packaging materials from inside and outside of the griddle before assembly, then
review and inspect all parts by referencing the parts list. If any part is missing or
damaged, do not attempt to assemble. Shipping damage is not covered under warranty.
Contact your dealer or Pit Boss® Grills Customer Service for parts: Monday through
Sunday, 4am - 8pm PST (EN/FR/ES).
[email protected]
Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
Tools required for assembly: screwdriver. Tool not included.