Environnement – Powerplus POWAIR0805 PNEUMATIC MULTI-USE TOOL FR Manuel d'utilisation
Page 10

POWAIR0805
FR
Copyright © 2014 VARO
P a g e
| 10
www.varo.com1
PROBLEMS
POSSIBLE CAUSES
REMEDIES
load
Cam clutch worn or
sticking due to lack of
lubricant.
can cause drag on high speed clutch
parts, i.e. a typical oiled/lubricated
wrench requires 1⁄2 ounce of oil.
GREASE
LUBRICATED:NOTE: Heat
usually
indicates
insufficient
grease
in
chamber. Severe operating
conditions
may
require
more frequent lubrication.
Tool runs
slowly. Air flows
slightly from
exhaust
Motor parts jammed with
dirt particles
Check air inlet filter for blockage.
Pour air tool lubricating oil into air inlet
as per instructions.
Operate tool in short bursts quickly
reversing rotation back and forth where
applicable.
Repeat above as needed.
Power regulator in
closed position
Air flow blocked by dirt.
Tools will not
run. Air flows
freely from
exhaust
One or more motor
vanes stuck due to
material build up.
Pour air tool lubricating tool into air inlet.
Operate tool in short bursts of forward
and/or reverse rotation where
applicable.
Tap motor housing gently with plastic
mallet.
Disconnect supply. Free motor by
rotating drive shank manually where
applicable
Tool will not
shut off
‘O’ rings throttle valve
dislodged from seat inlet
valve.
Replace ‘O’ ring.
Note: Repairs should be carried out by a qualified person.
14
ENVIRONNEMENT
Si votre appareil doit être remplacé, après une utilisation prolongée, ne vous en
débarrassez pas avec les ordures ménagères mais destinez-le à un traitement
respectueux de l'environnement.