Dell XXX - Manuel (Page 28)

28 Product Information Guide
www
.d
e
ll.c
om |
su
ppo
rt.
del
l.
com
CAUTION: Safety Instructions
Use the following safety guidelines to help ensure your own personal safety and
to help protect your projector and working environment from potential
damage.
CAUTION: Use of controls, adjustments, or procedures other
than those specified in this documentation may result in
exposure to shock, electrical hazards, and/or mechanical
hazards.
CAUTION: SAFETY: General
• Be careful when handling the projector, as the projector and the surface
beneath it may become hot with use.
• The lamp becomes very hot with use. Let the projector cool for at least
30 minutes before removing the lamp.
• If you are replacing a lamp, follow the instructions in the Owner’s
Manual and the documentation that came with the lamp replacement
kit.
• Do not touch any part of the lamp. Projector lamps are very fragile and
may shatter if touched.
• Remove the lens cap before turning on the projector. Failure to do so may
cause the lens cap to reach high temperatures.
• To avoid damaging the projector and lamp, allow the cooling fan to run
for two minutes before turning off the projector.
• Do not block the ventilation slots and openings on the projector.
• Disconnect the power cord from the electrical outlet if the projector is
not being used for a long period of time.
• Do not use the projector in an extremely hot, cold, or humid
environment.
• Do not use the projector in areas susceptible to excessive dust and dirt.
• Do not use the projector near any appliance that generates a strong
magnetic field.
• Do not place the projector in direct sunlight.
• Do not look into the lens while the projector is on; the bright light may
hurt your eyes.
• To reduce the risk of fire or electric shock, do not expose the projector to
rain or moisture.
• To prevent electric shock, do not open or disassemble the projector
further than what is needed for lamp replacement.