Diamond Power Products 3100 Psi - Manuel (Page 9)

3. Place billboard (A) over holes on handle (viewing from
front of unit). Push the tree clips (B) into the holes (C)
until they sit flat against the billboard.
4. Insert spray gun holder wireform (A) through hole on
left side of handle (viewing from front of unit). Hold
wireform in place and attach a plastic knob (B) from
inside of unit. Tighten by hand.
5. Insert “L” bolt (A) through hole just below billboard on
right side of handle (viewing from front of unit). Hold
bolt in place and attach plastic knob (B) from inside of
unit. Tighten by hand.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
NOTE: Verify provided oil bottle is the correct viscosity for
current ambient temperature.
• Refer to engine operator’s manual and follow oil and
fuel recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine operator’s manual for recommendations.
7
A
B
C
A
B
A
B
NOTICE
Any attempt to crank or start the engine before it has been
properly filled with the recommended oil will result in
equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.