Campomatic WM850E - Manuel (Page 6)

PROGRAMMER KNOB “STOP”:
The stop function resets the washing machine. If, for any reason, you want to
change the wash programme or add more washing to the load during the wash
cycle, simply place the programmer knob in position “ STOP”, then re-position the
knob on the new programme and press the “ START” button.
GB
USING THE WASHING MACHINE
DELAYED START:
The machine is fitted with a delayed start function. This allows the washing machine to be
programmed to start the wash cycle up to 8 hours later. The delay in hours can be selected
as follows: press the button to set a delay of 1, 2, 4, 8 hours. When the START button
( L) is pressed, the selected led will flash or button (I) will light up (according to the
model), signalling that the function has been activated. The machine will wait for
the number of hours set to elapse and then start the wash cycle automatically.
START BUTTON:
After having carried out all the operations described in points 1 to 8 in the paragraph
"WASHING CYCLE" press this button and the washing machine will begin its washing cycle.
The relative LED will light up after 2-3 seconds, to indicate that the door is locked and the
program has started.
6
Warning!! only use this function if strictly necessary and then only if the programme to reset has
been running for a few minutes. Before opening the door after a reset, wait 2 minutes for the
locking mechanism to release.
OPTIONAL FUNCTIONS
PREWASH:
Press this button to run a short wash at a maximum temperature of 40 °C of approximate
duration 10 minutes. This function can only be used with the “ COTTON” and “SYNTHETIC”
programmes and DAILY"
ENERGY WASH:
Press the button and the machine will carry out a wash cycle at the set temperature but
lasting longer.
The button is active with " COTTON" and "SYNTHETICS" programs.
N.B. When using this function, remember to put some detergent in the pre-
wash compartment too.
If one of the following buttons is selected, the corresponding LED will switch on. But if it has been
selected by mistake or you have changed your mind, simply press it again to cancel the selection.
VARIABLE SPIN:
The machine offers a wide selection of spin speeds that can be selected beforehand according
to the wash programme. To change the spin speed, simply press button ( H) to select the required
speed. The corresponding speed led will light-up each time the button is pressed. To exclude
the spin, select the led corresponding to symbol , if present, or the writing “no-spin”.
NB. the maximum spin speed will vary according to the model and is indicated by the Leds on the
machine. The maximum spin speed that can be selected for each programme is indicated by the leds
that light-up automatically when the wash programme is selected.
Spin load imbalance control:
This washing machine is equipped with a special electronic control system for correctly balancing
the wash load.
Prior to each spin, the system ensures that the washing is evenly distributed in the drum.
If the washing is not evenly distributed, the final spin speed is reduced, and if the load is very
unbalanced, the spin is not effected.
I
L
STOP
MAX
700
500
30
35
90 75
60
40
30
60
40
30
40 30 40
30
ºC
COLD
SILKS - WOOL
RINSES
COLD WASH
DRAIN SPIN
DAILY WASH
STOP
QUICK
HAND
SYNTHETICS DELICATES
WOOL
COTTONS
40
TURBOLOGIC XL WM850E