Campomatic CHD4070 - Manuel (Page 8)

8
chd4070
ENG
6. TROUBLESHOOTING
Dispenser does not operate.
- Make sure the power cord is properly connected to a working outlet.
Water is leaking.
- Bottle may have a leak. Remove bottle and replace with new bottle.
No water is coming from the taps.
- Make sure the bottle is not empty. If so replace it.
- Make sure to push the water controls in fully.
Cold water is not cold.
- Make sure the switch is on and the plug is in the socket.
- Check the fuse and replace if necessary.
- It takes up to one hour after setup to dispense cold water.
- Make sure the back of the dispenser is at least 15cm from a wall
Hot water is not hot.
- Make sure the switch is on and the plug is in the socket.
- It takes 15-20 minutes after setup to dispense hot water.
- Check the fuse and replace if necessary.
Dispenser is noisy.
- Make sure dispenser is positioned on a level surface with proper distance from
walls or enclosure cabinet.
Water tastes bad.
- Drain water from reservoirs and replace bottle with a fresh one.
- Clean dispenser as per Care & Cleaning instructions.
Electrical Leakage.
- Make sure the earth wire and the leakage protector are available
Refrigerator Compartment is not cooling.
- Make sure the refrigerator compartment door is properly closed
7. CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.