DCS ES36 EN - Manuel (Page 14)

12
INSTALLATION
9. Drill a 1/8” hole through the wooden bracket and drywall. These screws do not need to go into
the studs.
10. Screw two #10 X 3/4” pan head wood screws into the wood bracket, leaving 1/4” of the screw
exposed for hanging the hood.
11. Hang the hood using slots I in
Figure 6. Make sure the wood
bracket fits into the recess on the
back of the hood.
12. Level the hood and tighten screws
in slot I.
13. From inside the hood, drive 4 or 6
#10 x 3/4” pan head wood screws
(depending on model) through
holes J into wooden bracket.
14. Fix duct to transition with screws
and seal with duct tape. Screws
must not hamper the damper.
15. Drill a 3/8” hole through the center of the holes K into the wall. Insert two wall plugs into drilled
holes. Tighten hood to wall anchors by installing 2 screws with washers.
ASSEMBLY AND INSTALLATION
OF THE DUCT COVERS:
Optional duct covers shown in Figure 7
may be used to fill the space between
the hood and ceiling in wall mount
installations. 6” and 12” high duct covers
are available and may be ordered
separately.
1. If multiple duct covers are used,
connect the pieces together using
sheet metal screws provided with
chimneys.
2. Attach the duct cover(s) to the hood
using sheet metal screws as shown
in Figure 7.
J
I
K
FIG. 6
Go to page 14 to continue the installation.
Attaching
screws
FIG. 7