Danby DWBC14BLS - Manuel (Page 4)

3
INSTALLATION INSTRUCTIONS
Carpenter’s
Square
Measuring
Tape
Level
Drill & Hole Saw set
Gloves
Safety Glasses
Flashlight
70 1/16”/
178cm
26 7/8”* /
68.26cm
Electrical
Access: 2” /
3.81cm
Fig. B
23 3/4” / 60.33cm
Cabinets
must be
square
and
plumb.
TOOLS YOU
WILL NEED
WARNING: While performing the
installations described in this section;
gloves and safety glasses or goggles
should be worn.
PREPARING THE
ENCLOSURE
Electrical Requirements: The appliance must be connected to an individual,
properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker
or time delay fuse.
• It is recommended that you do not install the wine and beverage center into a corner (i.e. directly beside a wall).
This is to allow the door to have a greater than 90° opening swing. A limited door swing will prevent the shelves
from sliding out as intended, and may lead to damaging the door gasket.
• The rough cabinet opening must be on a level floor area and at least 267/8” (68.26cm) deep* by 233/4” (60.33cm) wide.
The opening should also have a height of at least 70 1/16” (178cm).
• The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the
shaded area (as shown in Fig. B).
Important: If the electrical outlet is surface mounted (not flush) within the enclosure, the depth requirement
for the installation may be affected.
• If the electrical outlet is located inside the adjacent cabinetry, cut a 11/2” (3.81cm) diameter hole to admit
the power cord.
IMPORTANT:
DOOR SWING
IMPORTANT: Do not include the door within the enclosure; leave it outside of the
enclosure to prevent the door swing from being obstructed.
Fig. B: The listed depth requirement for the installation is
assuming that the electrical outlet is located in the adjacent
cabinetry or is flush mounted in the rear wall, not surface
mounted in the enclosure.