Danby DCR017A2WDB - Manuel (Page 6)

Operating Instructions
TEMPERATURE
SELECTION
To avoid vibration, the unit must be on a level surface. This is
accomplished by adjusting the leveling legs located under the refrigerator.
The temperature of the refrigerator is controlled by setting the thermostat
knob to a desired setting.
BEFORE USING
1. Before the refrigerator is plugged in make sure the electric voltage to
be used is the same as the rated voltage. The power plug should have
its own independent socket. Using an adapter may cause the socket to
overheat.
2. Do not store flammable materials such as ether, benzine, LP gas and
glue etc in the refrigerator.
3. Do not splash water on the refrigerator, it may cause a malfunction or
electric shock.
4. When operating the refrigerator for the first time, run it without loading
any food until it auto stops at the desired temperature, usually it takes
2 or 3 hours. Then set the thermostatic dial at the setting desired and
put food in the refrigerator.
Features
1) THERMOSTAT DIAL: For controlling the temperature
inside the refrigerator; the compressor activates as
soon as the temperature rises above the desired level.
2) FREEZER COMPARTMENT WITH FREEZER DOOR:
Separate freezer section can hold small items.
3) WIRE SHELF
4) DRIP TRAY: Catches the water that drips off the
evaporator when defrosting. (not shown)
5) MAGNETIC GASKET: Tight fitting door seal keeps all
the cooling power locked inside. No hooks or latches.
6) BOTTLE RACKS: For tall, small and medium cans or
jars.
7) Leveling legs: Adjust so the unit is leveled on the
surface.
1
2
3
5
6
1.The temperature of the refrigerator can be adjusted by turning the
thermostatic dial. A medium setting of the thermostatic dial is the most
suitable for general operation. (Fig.B)
2.Defrost the freezer compartment whenever the layer of frost on the
surface of the evaporator reaches 3 or 4 mm. When defrosting, remove
all food and set the thermostat to the “OFF” position. Put the drip tray
under the evaporator to collect melted water. After the frost has melted,
discard the melted water and dry up the interior of refrigerator. The
refrigerator can then be restarted by turning its thermostat to the desired
setting.
Fig.A - MAX Fig.B - MED
7
5