Philips 10000104 - Manuel (Page 38)

3M CLEANING AND MAINTENANCE
GRINDER MAINTENANCE
The grinder needs a slight adjustment to make the coffee always its best after many grinding cycles
(approximately 2000).
WARNING!
This operation should be carried out carefully and by an experienced user. Empty the coffee bean hopper
The screw could fall info the grinder; if if happens remove if before restarting the machine.
The snap is signalled by a message on the coffee bean hopper; refer to these messages when this
adjustment is performed.
Unscrew the screw that holds the
service door closed.
Remove screws and service door. Adjust until if clicks.
Then reposition the door and attach if with the previously removed screw.
MILK CONTAINER CLEANING
To guarantee that the parts that come info contact with milk are perfectly clean and to optimize the
performance of your Primea Cappuccino, we recommend cleaning the appropriate container under running
wafer before dispensing milk-based beverages. To simplify this operation, the machine is equipped with a
special accessory (cleaning pin) that eliminates any milk residue in the cappuccinafore (see fig. 3).
This operation must be performed between two dispensing cycies of milk-based beverages (regardless of
when the last circuit rinse cycle was performed, see manual), while if is not necessary in case of consecutive
dispensing.
Rinse the container and the
cleaning pin under running wafer.
Proceed with caution!
Insert the cleaning pin all the way
info the indicated hole.