Toa N-8000AF - Manuel (Page 12)

12
6. WIRING
6.1. Connection Diagram
[General description of connection]
For cables, refer to p. 14.
1. Power supply connection
Connect the supplied power supply cord to AC
Mains or a UPS (Uninterruptible power supply).
About power supply cord handling
The supplied power supply cord is designed for
exclusive use with the N-8000AF.
Use the supplied power supply cord only with the
N-8000AF.
2. Audio output terminal connection
Connect the mixer, power amplifier, etc. to this
terminal using the two-core shielded cable.
[Audio output terminal specifications]
0 dB* 6 , 600 Ω, balanced.
This terminal outputs line level audio signal.
H: Hot
C: Cold
E: Earth
* 6 0 dB = 1 V
1 2 3 4
* 2
* 4 * 5
* 3
Be sure to ground.
To AC mains or a UPS
(Uninterruptible power supply system)* 1
Note
If there is a danger of lightning strikes,
insert an appropriate surge arrester into
the power line.
To mixer, power amplifier, etc.
To microphone,
audio device, etc.
To network
RJ-45
connector
N-8000AF
Connected
Unit
Hot (H)
Cold (C)
Earth (E)
Make connections as follows when the connected
device has unbalanced inputs.
N-8000AF Audio interface unit
Contact input
signals
Contact input
signals
Contact output
signals
Contact output
signals
5
5
6
6
7
* 2
3P removable terminal plug (supplied with the N-8000AF)
* 3 2P removable terminal plug (supplied with the N-8000AF)
* 4 5P removable terminal plug (supplied with the N-8000AF)
* 5 8P removable terminal plug (supplied with the N-8000AF)
To program timer, etc.
* 1 Select an appropriate UPS taking into consideration the total power consumption of all system components and the
required back up time, and also the requirement that the UPS should employ the on-line power system.