NEC MultiSync MT810 - Manuel (Page 3)

USERS MANUAL
A WARNING
• Only use your LCD projector on a solid, level surface. If the projector falls to the ground, you can be injured and the projector severely damaged.
• Do not use the LCD projector where temperatures vary greatly. The projector must be used at temperatures between 32T (0°C) and 104°F (40°C).
• Do not expose the LCD projector to moisture, dusL or smoke. This will harm the screen image.
Screen size = dlagonal(inch)
• Ensure that you have ad­
equate ventilation around
your LCD projector so heat
can dissipiate. Do not cover
the vents on the bottom or
the side of the projector.
Ceiling Installortion
Installing your Multisync
MT810 LCD Projector on the
ceiling must be done by a
qualified technician. Contact
your NEC dealer for more in­
formation.
Do not attempt to install the
projector yourself.
NOTE : Distances may vary ±5%.
Distance from lens surface
If your projector is mounted on the ceiling and your image is upside down, use the
“Menu” and “Select” buttons on your projector cabinet or (A) (▼) buttons on your
remote control to correct the orientation. (See page 60.)
Reflecting The Image
Using a mirror to reflect your LCD projector's image enables you to enjoy a much
larger image. Contact your NEC dealer if you need a mirror.
If you're using a mirror and your image is inverted, use the “Menu” and “Select”
buttons on your projector cabinet or (A) (▼) buttons on your remote control to correct
the orientation. (See page 60.)
Rear Screen Projection
You can use your Multisync MT810 LCD projector to project an image from the rear
onto a transparent screen. The distance the projector must be from the screen is the
same as if you were projecting the image from the front. Contact your NEC dealer if
you need a transparent screen.
If you're projecting the image from the rear and your image is inverted, use the “Menu"
and "Select" buttons on your projector cabinet or (A) (▼) buttons on your remote
control to correct the image. (See page 60 .)
INSTALLATION
1
3-17