Kenwood KAC-526 - Manuel (Page 2)

Controls
Operations of the following control and switches are required in accordance with the center,
unit and speakers connected with this unit.
0) RCA CABLE GROUND LEAD terminal
® OPERATION switch
This switch aiiows to select the amplification method of input signals.
• STEREO position
The input left and right signals are amplified separately. Use this position when the unit is as a
stereo amplifier.
• MONO (Lch) position
Amplifies the signal input from the left side only. Set to this position and make bridged connections
to use as a high-power monaural amplifier. (The input right signal is not output.)
(D INPUT SENSITIVITY control
Set this control according to the pre-output level
of the center unit connected with this unit, or to
the maximum power output of the genuine-
accessory car stereo;
Maximum power
output of genuine-
accessory car stereo.
Center unit
preout level
Amplifier input
sensitivity
10 w
300 mV MAX (0.15 V)
1 NOTE 1 800-1000 mV 0.3 V
For the pre-output level or the maximum power
output refer to the "Specifications" in the
instruction manual of the center unit.
15W 1.5V 0.5 V
25 W 2-4 V 1.0V-MIN
0 LINE IN terminal
(D SPEAKER LEVEL INPUT terminal
(D FUSE 115 A)
(7) BATTERY terminal
(8) GROUND terminal
d) POWER CONTROL (REMOTE) LEAD terminal
® SPEAKER OUTPUT terminals
2 English