Cleaning the ice maker system – Whirlpool 2180633 Manuel d'utilisation
Page 11
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

C L E A N I N G Y O U R I C E M A K E R
Cleaning the ice maker system
A
warning
Personal Injury Hazard
Most ice machine cleaners are citric or
phosphoric acid which can cause
irritation even after dilution. In case of
contact with eyes, flush eyes thoroughly
with fresh water and contact a physician
immediately. In case of contact with
skin, rinse well with water. If swallowed,
give large amounts of water and contact
a physician immediately. Do not induce
vomiting. KEEP OUT OF REACH OF
CHILDREN.
1. Turn the Cycle Control Knob to “OFF."
2. Remove the two thumb screws and slide
the ice cutter grid forward, out of the two
slots near the water pan.
3. Unplug the electrical harness.
NOTE: Any ice on the grid should be
melted under running warm water. At
tempting to pick the ice slab off the grid
may stretch and damage grid wires.
4. Remove all ice from the storage bin and
the freezing plate.
5. Drain the water pan by removing the drain
plug and then replace the plug.
11