Panasonic RP HC100 - Manuel (Page 2)

Precautions
Listening caution
Do not play your headphones at a high volume.
Hearing experts advise against continuous extend­
ed play.
If you experience a ringing in your ears, reduce
volume or discontinue use.
Do not use while operating a motorized vehicle. It
may create a traffic hazard and is illegal in many
areas.
You should use extreme caution or temporarily
discontinue use in potentially hazardous situa­
tions.
Sound can be deceiving. Over time your hearing
“comfort level” adapts to higher volumes of sound.
So what sounds “normal” can actually be loud and
harmful to your hearing.
Guard against this by setting your equipment at a
safe level BEFORE your hearing adapts.
To establish a safe level:
• Start your volume control at a low setting,
•Slowly increase the sound until you can hear it
comfortably and clearly, and without distortion.
Once you have established a comfortable sound
level:
•Set the dial and leave it there.
The serial number of this product can be found
on the label under the right ear pad.
Please note them in the space provided below
and keep as a permanent record of your pur­
chase to aid identification in the event of theft.
MODEL NUMBER______ RP-HC100
SERIAL NUMBER_________________________
Notes on use
The battery is used by the noise cancelling func­
tion and, even without it, the unit functions as a
normal pair of headphones.
This noise cancelling function mainly reduces low
frequency sounds below 1500 Hz. For this reason,
sounds with higher frequency portions remain rela­
tively intact.
The noise cancelling function acts to make a qui­
eter listening environment in places with a lot of
noise. Turn the function off when listening in
places that are already quiet.
Noise may occur due to dirt on the plug. Clean the
plug with a soft dry cloth if this occurs.
Product Service
Do not attempt to remove the cover{s) or repair
the unit yourself. ‘Refer servicing to qualified per­
sonnel only.
Product information
For product service, product information or assis­
tance with product operation, refer to the servicen-
ter directory.
User memo:
DATE OF PURCHASE
DEALER NAME_______
DEALER ADDRESS _
TELEPHONE NUMBER
Ш
1
4,5
Specifications
Using the headphones Q
1. Turn down the volume on the audio
equipment and insert the headphone
plug [3.5 mm (Va in.) stereo mini] into
the headphone jack.
2. Check the sides (L and R), then put
them on. Move the sliders up and
down to suit the housing position to
your ears.
3. Start play on the audio unit and adjust
the volume.
4. If noise cancelling is required, move
the OPR switch, located on the right
side housing, to the ON position.
The OPR lamp lights up.
5. Move the OPR switch to the OFF posi­
tion if noise cancelling is not required.
The OPR lamp goes out.
The unit acts like normal headphones in this
case.
How to fold the
headphones
в
1. Slide the headband down as far as
possible.
2. Push the two sides together and up.
Type; Dynamic, close-type
Driver units: 36 mm (V/ie in.) diameter
Impedance: 35 Ohms at 1 kHz (when OPR is on)
55 Ohms at 1 kHz (when OPR is off)
Sensitivity: 100 dB/mW (when OPR is on)
102 dB/mW (when OPR is off)
Frequency response: 8-22,000 Hz
Frequency range of active noise reduction:
40-1,500 Hz, more than 10 dB at 300 Hz
Power handling capacity: 1,000 mW
Power requirement; DC 1.5 V
(R03/LR03, AAA, UM-4 dry cell batteryx 1)
Battery life: Approx. 25 hours
(R03 manganese battery)
Approx. 50 hours (LR03 alkaline battery)
Cord: Approx. 1.5 m (4.9 ft.) long
Plug: Stereo mini-plug [3.5 mm (Ya in.) diameter),
L-type, gold plated
Weight:
Approx. 145 g (5.12 02 .) (without cord and battery)
Approx. 175 (6,18 02 .) (with cord and battery)