Panasonic CY-M7002EUC - Manuel (Page 4)

Location of Controls
20A ВАТТ GND CONT
OtJtJ
©
ò e
POWER MODE FILTER
MONO ST
Ф1.0
6 0 © О 0
^ For used in stereo:
® » © ®
For used in monaural:
®:(-)
®:(+)
© : Left side (-)
S u U U ® : Left side (+)
Input Connector
For used when the tape
player/radio’s preamp out­
put connector is an RCA-
type. Remove the insulat­
ing cap before connection.
Insulating cap
O
Fuse(20A)
This fuse is for circuit protection
O Power Supply Terminal
For connection with the power supply
O speaker Output Terminal
For connection with the speakers.
O
Power Indicator
Lights up when the power of the tape player/radio
connected to this unit is switched on.
0
Mode Selector Switch
Used for selecting the mode according to this
unit’s operating condition.
0 Filter Selector Switch
Used to change the cutoff frequency of sub­
woofer output.
0
Level Adjust Volume
Used for adjusting the amplifier output level.
0 Input Connector (RCA Terminal)
Used when the tape player/radio’s output con­
nector is an RCA-type.
Operation Procedures
For your driving safety, keep the volume level low enough to be aware of road and traffic conditions.
Precautions:
■ This unit is designed to be used with a Panasonic tape player/radio model.
■ This unit is automatically switched on and off if the power switch of the tape player/radio is turned on and
off. The power indicator lights up when the tape player/radio is turned on.
■ Due to its large output, the current consumption of the unit is also large; therefore, the unit should not be
used when the engine is turned off. Otherwise, the battery may deteriorate so that starting of the engine
may become impossible.
■ When using this unit, the speaker cord (supplied with the speaker) must be connected as shown in the il­
lustration below;