Panasonic Hi-Fi Professional/Industrial Video DS850 - Manuel (Page 61)

Error displays
When an error appears on the counter display, it means that a malfunction has occurred in the unit. When this
happens, terminate operation without delay and remedy the trouble by following the instructions In the Instruction
Manual.
Error display Problem Remedy
d Condensation
Leave power on and wait until error display is
cleared (see MEMO below).
c n *
C - U
Malfunction in fan
motor section Turn off the power and switch it back on again, and
check that the unit operates normally.
E - P
Malfunction in elevator
section
This occurs when the cassette has not been
inserted properly. Turn off the power and switch it
back on again, and check that the unit operates
normally.
E - 3
Malfunction in loading
section
E - H
Malfunction in cylinder
section
This occurs when a heavy load is applied because
condensation has formed on the tape or for some
other reason. Turn off the power and switch it back
on again, and check that the unit operates normally.
E - S
Malfunction in reel
section
E - S
Malfunction in tension
section
E - 1
Malfunction in
solenoid section
Turn off the power and switch it back on again, and
check that the unit operates normally.
Contact your authorized dealer if the unit does not function normally when the above remedial action has been taken.
*Fan motor error display
WARNING
(FAN MOTOR LOCK)
When trouble occurs in the fan motor area, the warning display
shown on the left is output to the monitor screen alternately with the
regular counter display. Since the unit’s power will be automatically
turned off about 2 0 minutes after this warning is output, complete
the work speedily and turn off the power. The power can be
switched back on in about
2 0 minutes’ time.
MEMO
Condensation
This phenomenon is caused by the same principle under which droplets of moisture (condensation) form on a
window in a heated room when it is cold outside. It can occur when the unit or a tape is moved to a location with a
significantly different temperature or humidity. It also occurs:
• When the unit or tape is moved to a location full of steam which cannot escape or a location with a high humidity,
or immediately after movement to a heated room
• When the unit or tape is moved quickly from a cold or cooled location to a high-temperature and/or high-humidity
location
c
SHOULD A MALFUNCTION OCCUR, TURN OFF THE POWER IMMEDIATELY,
TAKE HOLD OF THE POWER PLUG AND DISCONNECT IT FROM THE POWER
SOCKET AND CONTACT YOUR DEALER. CONTINUED USE MAY CAUSE
FURTHER DETERIORATION OR LEAD TO AN ACCIDENT.
61