Panasonic stereo/mono bridgeable power amplifier cy-m7052euc - Manuel (Page 8)

Electrical Connection
Before wiring:
• This unit is to be used only in a 12-Volt, DC battery system (Car) with negative ground.
• Remove the covering of the leads about 5 mm long from their ends before connecting.
• Disconnect the cable from the negative (-) battery terminal (see note below).
Note:
For installation in cars with trip or navigational computers, all electronic memory settings previously regis­
tered in the computer will be lost when the battery terminal is disconnected. For this type of car, battery
should not be disconnected. Therefore, extra care should be taken to prevent short circuiting.
Please read the operating and installation instructions for the your car audio carefuily before connecting to
this unit.
Power Cord (Option)
To battery’s (+) terminal.
Ground Cord (Option)
Connect to a well grounded
metallic part of your car.
Amp. Relay Control Cord
(Option)
To radio antenna relay control
cord.
Side View (Output Side)
(3) Terminal cover for short-
circuit prevention
Side View (Input Side) Left Speaker Right Speaker
Bridged Connection '
Sub'Woofer
IConnect sub­
woofer’s ©cord to
R+ (BRIDGE©),
connect sub­
woofer’s ©cord to
L-(BRIDGE©).
Both of left and right channel of the input connector should be connected. The amplifier will not work if both con­
nections are not made properly.
Terminal cover for short-circuit prevention
This terminal cover is for preventing sbort-circuit be­
tween adjacent terminals. Before connecting each
lead, pass it through the terminal cover. After connect­
ing the leads to the terminals, cover the speaker out­
put terminals and power terminals with this cover.
Make sure that the projections to prevent slipping out
are facing down.
Terminal cover for
short-circuit prevention
C Y-M 7052EU C