Petsafe Comfort Fit Remote Trainer - Manuel (Page 7)

www.petsafe.net 7
Fit the Receiver Collar
Important: The proper fi t and placement of your Receiver Collar is important for
effective operation. The Contact Points must have direct contact with your dog’s
skin on the underside of his neck.
To ensure a proper fi t, please follow these steps:
1. Make sure that the battery is not installed
in the Receiver Collar.
2. Have your pet standing comfortably (3A).
3. Centre the Contact Points underneath your dog’s neck,
touching the skin (3B).
YES
NO
3A
Note: It is sometimes necessary to trim the hair around the
Contact Points to make sure that contact is consistent.
3B
4. The PetSafe QuickFit™
Collar is designed so you can
quickly attach and remove
the Receiver Collar from your
dog while maintaining the
desired fi t.
a. With the Snap Buckle
fastened (3C), thread
the collar through the
Metal Buckle (3D).
Snap Buckle “C” Loop
Metal Buckle
3C 3D
b. Slide the excess collar through the “C” Loop on top of
the Snap Buckle (3E). This will hold the collar in place.
c. Once the collar fi t is determined, simply use the
Snap Buckle to remove and replace the collar.
5. The Receiver Collar should fi t snugly, yet loose enough to
allow one fi nger to fi t under the strap (F). Allow your dog
to wear the collar for several minutes, then re-check the fi t.
3E
Check the fi t again as your dog becomes more comfortable
with the Receiver Collar.
6. Trim the collar as follows:
a. Mark the desired length of the collar with a pen. Allow for
growth if your dog is young or grows a thick winter coat.
b. Remove the Receiver Collar from your dog and cut off excess.
3F
Step
3