Voltage Valet HS2 - Manuel (Page 4)

The hair straightener plates are hot when 10.
in use. Do not let eyes and bare skin
touch heated surfaces.
Do not place the hair straightener direct- 11.
ly on any flammable surface while it is
hot or plugged in. Place ONLY on a flat
heat-resistant surface.
Do not use an extension cord with this 12.
appliance.
SAVE THESE
INSTRUCTIONS
WARNING —This appliance heats to an
extremely high temperature and the follow-
ing will safeguard you from the straight-
ener being used incorrectly.
SPECIAL INSTRUCTIONS
To avoid a circuit overload, do not operate
another high wattage appliance such as
a hair dryer, etc., at the same time on the
same circuit.
This appliance has an automatic cut off
switch that shuts the straightener off
should it overheat.
If any fault occurs do not attempt to repair
it by yourself. This appliance has no user-
serviceable parts.
OPERATING INSTRUCTIONS
Plug the appliance into a 100, 120 or 1.
240 VAC electrical outlet. NOTE: This
appliance automatically operates from
100 to 240 VAC which eliminates the
need for a voltage selection switch.
A Voltage Valet adaptor plug may be
required to modify the appliance plug to
fit 240 VAC foreign electrical outlets.
Move the ON/OFF switch to the ON posi- 2.
tion. A blinking Red light appears near
the ON/OFF switch when the plates are
heating. When the desired temperature
is reached the Red light stops blinking.
Adjust the temperature dial from Low 3.
to High according to hair texture (lower
temperatures for thin hair, higher tem-
peratures for thick hair).
Low temperature approx. 176 °F
High temperature approx. 430 °F
After approximately 90 seconds the 4.
appliance is ready to use. The Red light
will stop blinking.
Proceed with hair styling. Do not jerk, 5.
twist or strain the power cord during use.