Attwood X3 - Manuel

R3 / X3 Handle
Installation
Instruction Sheet
R3 / X3 Series
Instructions:
1. Insert handle into the opening of the trolling motor head as shown in Figure 1. Press firmly until there is no
gap between the trolling motor head and the black portion of the handle.
2. Rotate handle in both directions to ensure that the maximum speed indicator for forward and reverse align
with the rotational stop.
3. Extend the handle and pull firmly to ensure that it is
properly locked in place.
Note: Handle installation is permanent. Do not attempt to
remove the handle.
© 2014, MotorGuide 69543 Rev A For questions, contact Consumer Affairs at 1-920-929-5040
www.motorguide.com
Figure 1
CAUTION! Before working on trolling motor, be sure that the battery
cables are not connected to the battery.