Sony SPP-S9001 - Manuel (Page 9)

Notes
• When you increase the sound volume, in some cases the back ground noise may be increased as well.
You should adjust the volume accordingly.
• If the handset beeps every second during conversation, move closer to the base unit; otherwise, the call
will be disconnected after one minute.
Tip
You can save battery power by setting the RING switch on the
bottom to OFF.
The handset won’t ring, but you can still make calls. You can also
receive calls if another telephone connected to the same line rings
to inform you of incoming calls. However, you cannot page the
handset from the base unit.
RING
switch
If the battery becomes weak during a call
The handset will beep twice per second with the ВАТТ LOW lamp flashing at the same time.
Finish your call and charge the battery pack.
For optimum performance, charge the battery for a fuil 12 hours.
Note that during the initial charge time (approx. 10 minutes) the ВАТТ LOW lamp lights up
and the phone cannot be used.
After the ВАТТ LOW lamp goes off, you may be able to use the phone, but the battery
duration will be very short; thus it is recommended that you fuily charge the battery before
next use.
Redialing
1
Press (TALK), and wait until the TALK button lights up.
2
Press C REDIAL) to redial the number last dialed.
Note
If the number exceeds 32 digits or if it is erased, five short error beeps will alert you that the number cannot
be dialed.
To erase the last phone number dialed
Press (REDIAL) twice.
The number will be erased from the memory, and you’ll hear a long confirmation beep.