Sony TCD-D8 - Manuel (Page 25)

Power Sources
Replacing the batteries
HOLD/PUSH OPEN
Display
тз
О
ё
(D
1/1
О
С
т
п
fO
(Л
Tips
• This tape-corder is not
equipped with a power
switch. As a result, the
LCD display will
always heJurned on as
long as the batteries are
inserted. However,
power consumption is
minimal and negligible.
• Especialy when the
tape-corder is in the
low-power
consumption mode, all
indicators da-not
disappear in the
display immediately
after removing the
battery holder from the
tape-corder. Cancel the
low-power
consumption mode
before removing the
battery holder. If the
batteries are replaced
before all indicators
disappear in the
display, the reniaing
battery power may not
be displayed correctly.
• The clock will return to
its default setting (SU/
95Y1M1D/
AM12HOOMOOS)if the
batteries are removed
from the tape-corder
for one hour or more.
In this case, set the
clock again.
Note
Remove the batteries
when the tape-corder is
not to be used for an
extended period of time.
1
2
Remove the battery holder. (Sec page 4.)
Replace the batteries with new ones in the battery
holder. (See page 4.)
Make sure that all indicators disappear in the
display.
Insert the battery holder into the tape-corder and
close the lid. (See page 4.)
When to replace the batteries
The status of the remaining battery power is
displayed when the batteries are used.
Battery full.
3
4
ВАТТ
-ф
Ф
Ф
^ \ \ \ \ \ i t s ! ,
' Е ВАТТ F-
' i i i t ! I М V ^
Replace all four batteries with new
ones.
" b n J I r h ' b " flashes and the tape-
corder enters the stop mode when
usecf beyond this point.
Battery life (Approx, hours)
Battery Playback Recording
(in the recording
monitor mode)
Sony alkaline (size AA) 3.5 3(4*)
Sony rechargeable (size AA) 2 1.5(2*)
Values for battery life at 20°C.
Battery capacity decreases and battery life becomes
shorter in low temperatures.
* When no plug is connected to the PHONES/LINE
OUT jack.
Power Sources 25"