FRIGIDAIRE FGES3045KW - Manuel (Page 5)

5
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
6
The metal flange under each side of the cooktop MUST be placed over
the cabinet countertop for proper unit support. The cooktop should
NOT rest directly on the countertop (see illustration 2) or else it could
cause damage to the cooktop voiding the warranty. Level the unit if
needed.
7
After the installation, MAKE
SURE that the unit is supported
by the leveling legs and NOT by
the cooktop.
1
The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1)
H1
H2
H3
H4
Illustration 1
Shave Raised
Edge to
Clear Space
for a 31½"
(81 cm) Wide
Cooktop.
1 ½" Max.
(3.8 cm Max.)
Illustration 2
To successfully
install the range,
the initial level
height from floor
to underside of
cooktop frame
should be at
least 1/16"
taller than
cabinet sides
as measured in
step 2.
Metal
Flange
To avoid breakage: Do NOT handle or manipulate
the unit by the cooktop.
2
Before installing the unit,
measure the heights of
the two (2) cabinet sides
(H1-4), front and back (see
illustration 1) from the floor
to the top of the counter.
3
Level the range using the four (4) leveling legs so
that the height from the floor to the underside
of the cooktop glass frame is greater than the
tallest cabinet measurement by at least 1/16" (see
illustration 2).
4
Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center of
the cabinet cut-out.
5
Remove the protective channels on each side of the cooktop (if provided).