Aerus Lux Floor Pro - Manuel (Page 15)

15
Solutions: A- Aerus Wood Wax B - Aerus Floor Cleaner C - Aerus Cleaner Plus, Floor Cleaner & Stripper
D - Aerus Tile Polish E - Aerus Turbo Shampoo
Note: A-D to be applied with a mist sprayer. E to be applied through dispenser tank.
APPLICATION GUIDE
Note: Before using the chart below, you should carefully read and understand the following statements.
These statements provide directions that apply to most floor types:
Surface
Vinyl, rubber,
asphalt, terrazzo,
stone, masonry &
other wax floors
No-wax floors
Original Wood
Floors
(non-laminate)
or cork floors*
Carpet
Solution
C
D
B
A
A
E
E
Required Accessory(s)
• Scrub brushes
• Green Scrub pads
• Mist Sprayer
• Scrub brushes
• Green Scrub pads
• Lambs wool pads or
disposable polishing pads
• Mist Sprayer
• Scrub brushes
• Lambs wool or
disposable polishing pads
• Mist Sprayer
• Scrub brushes
• Lambs wool
• Mist Sprayer
• Scrub brushes
• Lambs wool
• Mist Sprayer
• Shampoo brushes
• Naplifters
• Shampoo brushes
Application
• Spray a heavy, even mist of solution
• Spread and work in using scrub brushes or scrub pads (depending upon
degree of soiling and type of floor).
• Mop up dirty solution, rinse and mop.
• Spray a moderate, even mist of solution
• Spread and work in using scrub brushes or scrub pads (depending
upon type of floor).
• Polish surface using scrub brushes.
• Once dry, buff using lambs wool or disposable pads.
• Spray a thin, even mist of solution
• Spread and work in using scrub brushes
• Once dry, buff using lambs wool or disposable pads
• Spray a moderate to heavy mist of solution
• Spread and work in using scrub brushes
• Allow to dry
• Polish surface using scrub brushes
• Buff using lambs wool or disposable pads
• Spray a light mist of solution
• Spread and work in using scrub brushes
• Allow to dry
• Buff using lambs wool or disposable pads
• Dispense foam and work into carpet with shampoo brushes
• Allow to dry
• Naplift carpet then vacuum
• Dispense foam and work into carpet with shampoo brushes
• Allow to dry
• Vacuum (do not naplift)
• Always vacuum first.
• Apply solutions to a small area
at a time, approximately 3’x3’.
• Clean accessories with warm
water when finished.
• Scrubbing and polishing
requires scrub brushes.
• Clean out spray mister before
using.
• Never use green pads on easily
marred surfaces.
• Test carpeting for color
fastness and durability.
• Always unplug unit before
changing brushes or pads.
*Caution: Some finished wood floors are not suitable for wood floor wax
Type/Function
Stripping
Polishing
Cleaning
Wax finish
Wax touch-up
Plush or
cut pile
Berber, loop
or shag