Summit SEIH3536C - Manuel (Page 13)

12
Hood installation on ceiling (page 7)
e before use.
hood.
n
in
um distance from
ws and washers (Fig. 4).
c
4).
ructure using the nuts and washers (Fig.
Warning: Before connecting the hood: Switch off the electricity supply
voltage and frequency coincide with that
e
device local regulations.
 Remove the Styrofoam protective piec
 The accessories needed for installation are inside the
 Use the two screws to attach the reducer pipe H to the upper plate
(Fig. 1). Connect the 6” non-flammable pipe to the opening in the ceiling.
 Confirm that the ceiling will support the weight of the hood. Drill 4 holes
the ceiling using a 5/6” bit and insert the plugs (Fig. 2).
 Adjust the length of the telescopic structure and attach the two pieces with
8 screws and washers. Bear in mind that the minim
working surface to the base of the hood should not be less than 25” (Fig.
3).
 Attach the previously adjusted telescopic structure to the ceiling using 4
scre
 Introduce pipe J with the grate on the upper part and attach the telescopi
structure using 2 screws (Fig.
 Introduce pipe K and keep it raised (Fig. 5).
Affix the hood to the telescopic st

5).
 Lower pipe K and attach it to the hood with 2 screws (Fig. 5)
Connecting the hood to the grid
and check that the supplied
indicated on the appliance nameplate.
ct the hood directly to the electrical grid, protected by a separator
accessible for disconnection, in line with
Conn