Summit PHC115G - Manuel (Page 5)

4
INSTALLATION
Before Using the Warming Cabinet
• Remove the exterior and interior packing.
• Check to be sure shelves are installed and that the strips of tape
holding them in place have been removed.
• Level the appliance with the adjustable legs provided.
• The circuit breaker on the control panel should be in the OFF position.
• Clean the interior surfaces with lukewarm water using a soft cloth. Any
plastic odor that you notice when you first open the doors will dissipate
once the appliance is operating.
Installing Your Appliance
• This appliance is designed to be free-standing only, and should not be
recessed or built-in.
• Place your appliance on a floor that is strong enough to support it when
it is fully loaded. Be sure the appliance is level. (Level your warming
cabinet by adjusting the legs at the front.)
• Leave at least 2 inches of space between the back of the unit and the
wall behind, which allows for proper air circulation.
• Plug the unit into a 120V AC 60Hz electrical source. The fuse or circuit
breaker should be rated for 15 amperes.
• The unit is designed to be used in a stable environment where the ideal
ambient temperature is 72°F or less. Extremely warm or cold ambient
temperatures may cause the appliance to perform improperly.
• Avoid locating the warming cabinet in moist areas.
• This appliance is equipped with a three-prong plug and is grounded to
eliminate electrical hazards. In order to make it effective, the unit must
be plugged into a grounded electrical outlet.
• A short power-supply cord (or short detachable power-supply cord) is
provided to reduce risk resulting from becoming entangled in or tripping
over a longer cord.
• Extension cords (or longer detachable power-supply cord) are available
and may be used if care is exercised in their use.
• If an extension cord (or a long detachable power-supply cord) is used: