Limited warranty, About the vacuum cleaner, Handle assembly guide – Pullman Ermator HEPA VAC 2HP 12GL 102 DRY (102ASB-12PD) Manuel d'utilisation

Page 4: Wheel & caster assembly guide, Disposable bag changing

Advertising
background image

Handle Assembly Guide:

1. Remove and carefully set aside motor head and HEPA fi lter.
2. Remove the .250-20x1.25 hex bolt and .250-20 hex nut from

the bottom handle support.

3. Loosen the hex nuts that secure the clamps on the tank. Slide

handle through the two clamps mounted on the tank and onto
the handle support.

4. Reinstall the bolt and nut through the handle and handle

support.

5. Tighten the handle clamps and bottom handle support.

Wheel & Caster Assembly Guide:

1. Slide rear wheels onto axle of frame. Snap on hub cap covers.
2. Insert and push casters into the holes located at the front of the

vacmobile metal frame.

3. Lock the casters in place with the hub nuts, using a rubber

hammer.

Disposable Bag Changing:

We recommend that you replace your disposable paper fi lter bag
frequently to improve the life and performance of your vacuum. It
is also strongly recommended that you only purchase high quality
Pullman-Holt replacement disposable paper fi lter bags.

IMPORTANT: When vacuuming hazardous materials, we
recommend the following procedure for replacing the

disposable paper fi lter bag.

1. Remove vacuum head and HEPA fi lter.
2. Tape a 6-mil poly bag over the canister so that the canister is

completely enclosed.

3. Using the poly bag as a glove, disengage the disposable paper

fi lter bag from the vacuum inlet stem inside the canister.

4. Invert the canister so that the disposable paper fi lter bag falls

into the poly bag. Seal the poly bag and dispose as prescribed
by law.

5. Attach a new disposable paper fi lter bag to the vacuum

inlet securely and fold the top of the bag down so it does not
interfere with the HEPA fi lter.

6. Replace the HEPA fi lter and motor head.
7. Thoroughly vacuum the work area to recover any hazardous

dust which may have been dropped.

LIMITED WARRANTY

The vacuum cleaner is warranted for 1 year from the date of purchase as
shown on your distributor’s invoice. Parts not covered under warranty are
power cords, fi lters, motor brushes and squeegee blades. The warranty
covers only failure due to defective parts or workmanship and will be

invalidated by improper application and abuse.
In NO circumstance should you return a failed unit to the factory. If you
experience any problems with your vacuum during the warranty period,
contact the Customer Service.

10702 N 46th Street • Tampa, FL 33617
(813)971-2223 • fax (813)971-6090
www.p

hc.com

B704009

ABOUT THE VACUUM CLEANER

Hub Cap Cover
B703549

Hub Cap
B910073

Washer
B980556

Axle

Wheel
B703544

Hub Cap

B910073

Caster

B910518

(1)

(2 & 3)

Disposable Paper

Filter Bag

B524253

Poly Bag

B524263

04/13

Advertising