Brother P-touch PT-9500PC - Manuel (Page 83)

82
After printing
This section contains the procedures to remove the label backing from the printed label to remove.
Removing the label backing
When the backing of a printed label is not cut,
use the included label stick. For labels printed
using the Half Cut option, peel back the
backing from the cut line.
1
Press the cover release button and open
the tape compartment cover.
2
Remove the label stick installed inside
the PT-9500PC tape compartment cover.
3
Hold one end of the printed label with
one hand and hold the label stick with
the other hand.
4
Insert half of the printed label into the
hole in the label stick with the printed
side facing up.
5
Turn the label stick and quickly pull as
shown in the illustration below.
→
The end of the label will come off of
the backing slightly.
6
Completely remove the backing from the
label and affix the label.