Blodgett MT3855G-G - Manuel (Page 12)

Installation
8
Oven Assembly
FOLDING CONVEYOR
The folding conveyor assembly must be installed
from the control box side of the oven.
1. Unfold the right side of the conveyor.
2. Push the conveyor into the support tracks.
See Figure 6. Be careful to avoid hitting the
red emergency off switch on the side of the
control box.
3. Unfold the left side of the conveyor and contin-
ue to push into the support tracks.
4. Insert the conveyor in beyond the normal rest-
ing position.
5. Install the drive chain around the drive motor
sprocket and the conveyor sprocket. See
Figure 7.
NOTE: Figure 7 shown without chain guard
and control box cover for clarity.
6. Pull the conveyor back out of the oven until the
1/4-20 thumb screw can be installed through
the conveyor support and into the control box.
See Figure 8.
NOTE: If the mounting hole cannot be lined up or
the chain is too loose, the drive motor will
need to be repositioned.
Figure 6
Figure 7
Figure 8