Black & Decker DLX1050WC - Manuel (Page 6)

10 9
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Coffeemaker does not
turn on.
Coffeemaker is
leaking.
Brewing takes too
long.
Coffee is not brewing.
The coffee maker
brews clear water.
The one-piece cover
does not close.
Filter basket
overflows.
grounds in the
brewed coffee.
Coffeemaker is not
plugged in.
Water reservoir may be
overfilled.
Carafe may not be correctly
placed on “Keep Hot”
plate.
The coffeemaker might
need cleaning.
Water reservoir might be
empty.
There may be no coffee
grounds in the removable
filter basket.
Removable filter basket
may not be correctly
placed.
Carafe may be improperly
placed on the “Keep Hot”
plate.
The filter and/or the brew
basket are not properly
placed.
Check to be sure appliance is
plugged into a working outlet
and the On/OFF (I/O) button
has been pressed.
Make sure the water reservoir
has not been filled beyond the
MAX fill line.
Make sure carafe is placed
correctly on “Keep Hot” plate
and is centered under the filter
basket holder.
Follow procedure under
“Maintaining Your
Coffeemaker.”
Make sure water reservoir
has sufficient water to brew
desired number of cups of
coffee.
Add sufficient amount of
coffee grounds to paper lined
removable filter basket.
Remove filter basket and
replace correctly into holder.
Remove carafe and insert so
that carafe rests comfortably
within the grooves on the
“Keep Hot” plate.
Insert paper liner into filter
basket and insert basket
properly into holder.
• Do not allow all liquid to evaporate from the carafe while on the "Keep Hot"
plate or heat the carafe when empty.
• Discard the carafe if damaged in any manner. A chip or crack could result in
breakage.
• Do not use abrasive scouring pads or cleansers, they will scratch and weaken
the glass.
• Do not place the carafe on or near a hot gas or electric burner, in a heated
oven or in a microwave oven.
• Avoid rough handling and sharp blows.
POWER CORD STORAGE
For your convenience, the cord storage gives you the
flexibility to use the exact cord length needed and keep the
rest stored in the coffeemaker.
To increase the length, grasp the power cord and gently
pull it away from coffeemaker. To store excess cord, feed it
into the coffeemaker (J).
Important: Do not grasp and pull the power plug.
J