Exécution du programme tsetup -2, Exécution du programme tsetup, Чшхц – Toshiba Tecra 8100 Manuel d'utilisation
Page 110: L’écran system setup (2/2)

7-2 Configuration du système et sécurité
Manuel de l'utilisateur
Tecra 8100 User's Manual – 8100_FR.doc – FRENCH – Printed on 13/12/99 as IM8100FR
Exécution du programme TSETUP
1.
Sélectionnez Redémarrer l’ordinateur en mode MS-DOS
mode ?
dans la fenêtre Arrêter.
2.
Lorsque l’ordinateur redémarre en mode MS-DOS, tapez TSETUP et
appuyez sur Enter. TSETUP affiche l’écran SYSTEM SETUP.
L’écran de TSETUP est réparti sur deux pages, SYSTEM SETUP (1/2) et
SYSTEM SETUP (2/2).
MEMORY
Total = 65536 KB
BATTERY
Battery Save Mode = Full power
PASSWORD
Not Registered
DISPLAY
Power On Display = Auto-Selected
LCD Display Stretch = Disabled
Multi Display Adapt.= Single Adapt.
TV Config.
BOOT PRIORITY
Boot Priority = FDD->HDD->CD-ROM->LAN
HDD Priority= Built-in HDD->Second HDD
Power On Boot Select = Enable
PERIPHERAL
Pointing Devices = Auto-Selected
Ext Keyboard "Fn" = Disabled
USB Legacy Emulation = Disabled
Parallel Port Mode = ECP
Hard Disk Mode = Enhanced IDE (Normal)
SYSTEM SETUP (1/2) ACPI BIOS version = x.xx
CONFIGURATION
Device Config. = All Devices
I/O PORTS
Serial = COM1(3F8H/IRQ4)
Built-in Modem = COM2(2F8H/IRQ3)
Parallel = LPT1(378H/IRQ7/CH3)
FLOPPY DISK I/O
Floppy Disk = (3F2H/IRQ6/CH2)
DRIVES I/O
Built-in HDD
= Primary IDE(1F0H/IRQ14)
Int Selectable Bay
= Secondary IDE(170H/IRQ15)
PCI BUS
PCI BUS =IRQ11
SYSTEM SETUP (2/2) ACPI BIOS version = x.xx
PC CARD
Controller Mode = Auto-Selected
OTHERS
Power-up Mode = Resume
CPU Cache = Enabled
Level 2 Cache = Enabled
Processor Serial Number = Disabled
Auto Power On = Disabled
Alarm Volume = High
System Beep = Enabled
Panel Power On/Off = Disabled
ЧШХЦ :
€Select items Space, BkSp: Change values PgDn, PgUp: Change pages
Esc: Exit without saving Home: Set default values End: Save changes and Exit
L’écran System Setup (2/2)
Le paramètre Panel Power On/Off (Mise sous/hors tension à
l’ouverture/fermeture de l’écran) n’apparaît que lorsque l’ordinateur est en
mode Reprise.
L’option Built-in Modem (Modem intégré) n’est affichée que si un
modem est installé.